The Australian Transport Safety Bureau is investigating steering issues with two new ropax ferries recently put into service between across the Bass Strait
The Australian Transport Safety Bureau (ATSB) is investigating separate incidents involving steering issues on Spirit of Tasmania’s two new ropax ferries on their voyages to Tasmania.
In response to the incidents, operator TT-Line said that both vessels would suspend use of their autopilot systems during their transits of Port Phillip Bay.
TT-Line chairman Ken Kanofski told local media that the incident on Spirit of Tasmania IV involved a "frustratingly minor issue". An inspection when the vessel docked in Geelong showed a problem with the mechanical electrical processes in the steering console itself.
It’s an inauspicious start for the new vessels, which were welcomed enthusiastically to increase the available capacity on the Geelong, Victoria to Devonport, Tasmania route.
The ferry service provides a vital tourism lifeline; Tasmania attracted a record number of visitors – 1.4M - during the fiscal year ending March 2026.
Built by Finland’s Rauma Marine Constructions, each ship is designed to transport 1,800 passengers and 600 vehicles – an additional 470 passengers per sailing per ship.
The incidents
According to ASTB, the first incident involving Spirit of Tasmania V occurred on 24 October off Point Henry, Port Phillip, Victoria. The ropax ferry left Geelong at 19:56 under the conduct of a harbour pilot bound for Devonport, Tasmania, carrying 94 crew, 20 passengers and a cargo of freight vehicles. The voyage, which did not carry fare-paying passengers, was part of the ship’s operational testing in preparation for its full introduction to service starting on 31 October.
At roughly 20:30, the ship was being controlled using an autopilot system when it reached the junction between the Hopetoun Channel and Wilson Spit Channel to the northeast of Point Henry. A starboard turn was initiated, but the autopilot responded slowly, causing a wider-than-expected turn.
After adjusting the settings, the ship’s rate of turn increased, with the autopilot subsequently unable to arrest the turn. Steering control was then switched to manual, and the port rudder was applied to stop the turn. Subsequent attempts to control the ship’s heading resulted in increasing heading oscillations from port to starboard, resulting in the ship briefly moving outside the charted shipping channel’s southern and northern limits. To regain control of the ship’s movement, the vessel was then brought to a stop in the Wilson Spit Passing Channel to the south of the shipping channel’s limit before resuming its outbound voyage.
The second incident on sister ship Spirit of Tasmania IV occurred on 5 November while approaching Lonsdale pilot boarding ground to enter Port Phillip Bay. The ship was sailing from Devonport to Geelong carrying passengers and vehicles.
When steering control was changed from the autopilot to manual mode (follow-up), the steering wheel did not respond to helm commands. Control was then changed to emergency non-follow-up to embark the pilot while the ship’s engineers attempted to correct the fault. Once the pilot was on board, the ship aborted entry to Port Phillip Bay to further investigate the issue. Further attempts to transfer steering to manual mode were unsuccessful.
Subsequently, steering control was successfully transferred to the bridge wing. The ship then resumed its voyage to Geelong, where it docked. During the transit, it was accompanied by an escort tug as a precaution.
As part of its investigation, ATSB intends to collect evidence from both ships, interview personnel, and examine records and documentation, equipment inspection reports, and recorded data.
ATSB will publish a final report with the results of the investigation by the middle of next year.
Events
© 2026 Riviera Maritime Media Ltd.